Genuine SuperPINDA Probe Sensor for 3D Printers PINDA V3

Genuine SuperPINDA Probe Sensor for Prusa Zaribo PINDA V3


Genuine SuperPINDA with 1.5m Extended Cable Option

Genuine Pepperl & Fuchs Sensors

Cable Length
Out of Stock


Privacy Policy


Delivery Policy


Terms and Conditions

SuperPINDA is temperature-independent. With the higher quality sensor inside, it doesn't need a thermistor. Making the first layer calibration and mesh bed levelling much easier and consistent.

General specifications:

-Switching function Normally closed (NC)
-Output type NPN
-Rated operating distance sn 2.5 mm
-Installation non-flush
-Output polarity DC
-Assured operating distance sa 0 ... 2.03 mm
-Reduction factor rAl 0.45
-Reduction factor rCu 0.35
-Reduction factor r304 0.75
-Output type 3-wire

-Nominal ratings:

-Nominal voltage Uo 5 V
-Operating voltage UB 4.75 ... 5.25 V
-Switching frequency f 0 ... 800 Hz
-Reverse polarity protection no
-Short-circuit protection no
-Voltage drop Ud ≤ 1 V
-Operating current IL 0 ... 40 mA
-Off-state current Ir ≤ 50 μA
-No-load supply current I0 ≤ 10 mA
-Switching state indicator LED, red

-Compliance with standards and directives

-Standard conformity
-Standards EN 60947-5-2:2007EN 60947-5-2/A1:2012IEC 60947-5-2:2007IEC 60947-5-2 AMD 1:2012

-Ambient conditions

-Ambient temperature 10 ... 80 °C (50 ... 176 °F) 

-Mechanical specifications
-Connection type cable
-Housing material brass, nickel-plated
-Sensing face LCP, black
-Degree of protection IP65
-Cable diameter 3.5 mm ± 0.1 mm
-Material PVC
-Color black
-Core cross-section 0.14 mm2
-Length L
L1 = 2 m ± 25 mm
L2 = 50 mm ± 2 mm
L3 = 5 mm


Specific References


8 other products in the same category: