TFT70 LCD Display for Zaribo Level Cube by Bigtreetech

TFT70 LCD Display for Zaribo Level Cube by Bigtreetech


7 inch LCD Display with USB and SD Card support

In Stock!


Privacy Policy


Delivery Policy


Terms and Conditions

  • The touch screen uses a 32 bit ARM level Cortex-M4 series STM32F407VGT6, 168MHz frequency Microprocessor, which can perfectly replace the LCD12864 screen for use. Reserve the extended port for material break detection function (FIL-DET); Reserve the extension port of automatic shutdown after printing (PS-ON). 
  • High Compatibility. You can select two work modes, they are UART serial port screen mode and 12864 screen mode. The UART serial port screen mode supports two printing modes: an SD card and a USB stick. Updating the firmware via SD card is simple and convenient to use. 
  • 12864LCD mode uses EXP1, EXP2 and EXP3. EXP1 and EXP2 are LCD screen ports of a normal motherboard. EXP3 is the LCD interface used by the E3 series control board (such as SKR MINI E3 V2.0, SKR E3 Turbo, SKR E3 RRF, SKR MINI E3 V1.2, etc.) 
  • The WIFI interface is reserved, and the external WIFI module is supported to realize the WIFI function. Reserve 2 sets of UART serial port expansion ports to use for DIY. 

Specific References

15 other products in the same category: