This Bondtech Body Rebuild Set is only for customers who previously bought a Bondtech MK2.5/3 Upgrade Kit and have a Prusa i3 upgraded to MK3S.
Sunon 5V 40mm x 40mm fan with 65cm cable + connector
Sunon fans come with 65cm cable and with the necessary connector.
Type of fan DC
Kind of fan axial
Supply voltage 5V DC
Operating voltage 3.5...6V
Fan dimensions 40x40x10mm
Power consumption 0.83W
Current rating 0.138A
Fan efficiency 13.52m3/h
Noise level 27.3dBA
16 other products in the same category:
Sunon fans come with 25cm cable. This version has NO plug
Power switch with light, CE, VDE
Misumi L-bracket (needed for fastening the z-axis extrusions)
X-Carriage kit required to install our Bondtech Upgrade Kit for Prusa i3 MK3S.
These rods are for Zaribo printers. Hardened steel cut with precision by Misumi Engineers in the factory.
High-Quality Graphics LCD Display, 20x4 text display, with a flat(!) potentiometer for contrast which is fully compatible
Push-fit connector for 4mm PFTE tube. M10 thread.
224X254 0.20mm Thick PEI sheet for Prusa MK2/S with 468P 3M Adhesive on Glossy side
Cable can be used to extend 3 pin fan cable or needed for Zaribo MK 2.5 or Prusa MK 2.5 to connect Noctua to RAMBO board.
Post-Assembly Insertion Nuts with plastic stopper
Lifetime warranty against abrasion
Wear resistant, plastic repellent coating
High speed steel, hardened and tempered to 64 Rockwell C.
Available in multiple orifice sizes
Please allow up to 10 days for assembly.
Assembled Zaribo 320 MK3s Rel 3
New motor design. Extruder Motor stays much cooler during printing.
Cutter knife 2C handle with slide