Pulley for PowerGrip® GT®3. 1 piece
Extrudr BioFusion steampunk copper
0.8 kg Spool
Extrudr BioFusion is a new breed of excellent material, best suited for designers and makers who are looking for an extra shiny appearance of their printed parts. Besides the good and special looks, BioFusion is also stronger than standard PLA or PETG, so you can also use it for mechanical parts. The temperature resistance of the material is up to 75°C. As it is very easy to print and doesn’t require a heated bed or closed building chamber, not much experience is needed to get extraordinary results. Shine on!
- Super shiny look
- Good mechanical properties
- Temperature resistance up to 75°C
- Good Layeradhesion
- 100 % recycleable
16 other products in the same category:
242X260 0.20mm Thick PEI sheet for Prusa MK3 Spring Steel Sheet with 468P 3M Adhesive on Glossy side
Available from Sep. 15th
LMU8 Linear Bearings by Misumi
Sunon fans come with 65cm cable and with the necessary connector.
Lead screw integrated z-axis motor for Zaribo 320.
0.8 kg Spool
PINDA 2 probe is a proximity sensor with a special thermistor embedded inside.
Pack contains 1.5m red and 1.5m black 14AWG cable.
Length is sufficient for wiring PSU to Einsy or Rambo box on Zaribo frame.
Please allow up to 10 days for assembly.
Assembled Zaribo 420 MK3s Rel 3
Push-fit connector for 4mm PFTE tube. M10 thread.
Misumi endcaps for 3030 extrusions (black)
Contains 6 caps
Replacement Shaft assembly for our BMG, Single and Dualdirect extruders.
Including setscrew for primary 1.75/5.0 drivgear
Superior heat break performance
Increased structural rigidity
Larger temperature operating range
Modular/adaptable to almost any FFF/FDM printer
Ideal for multi-extrusion systems
LCD, cable length 70cm. Zaribo frame is a bit bigger and this cable is ideal for it, since it's longer than "standard" cable of 60cm.
The set has 2 cables for connection of 1 LCD to controller board.