0.8 kg Spool
Microswiss Plated Wear Resistant HeatBreak
This heat break is a direct replacement for use in E3D v6 1.75mm hot ends.
This tube made from stainless steel and plated with TwinClad XT coating. TwinClad XT is a very low friction Electroless Nickel composite coating, often used in injection molding because of it release properties. This high lubricity plating will prevent clogging in the critical zone of hotend, where filament liquidizes. It is also very hard and corrosion resistant. Great for high abrasion filaments like Carbon Fiber, Metal filled, Aluminates, etc.
Made in USA by Micro Swiss
16 other products in the same category:
Cleaning kit for extruder and hot end
0.8 kg Spool
Contains screws, dowel pin, t-nuts, corner brackets to upgrade from Rel2 -> Rel 3 plastic parts.
Cutter for Bowden tubes.
Dowel Pin 2.9mm x 14mm for x-idler
Fully assembled E3D V6 hotend for Zaribo MK2, MK2.5. 12V version. Not compatible with MK3
Sunon fans come with 25cm cable. This version has NO plug
High quality aluminum, excellently machined, finished smoothly.
Set has two pieces
Pulley for PowerGrip® GT®3. 1 piece
LDO Pancake Extruder Motor
Misumi endcaps for 3030 extrusions (black)
Contains 6 caps
Synthetic grease 3oz, 1 tube
LM8UU Linear Bearings by Misumi / THK
crimped cables 60cm, 2 pairs (black and red)