LMU8 Linear Bearings by Misumi
Smooth Rods for Original Prusa MK2(S) / MK3 by Misumi
These rods are for Original Prusa MK series printers. Hardened steel cut with precision by Misumi Engineers in the factory.
Package contains 2 rods of the desired length.
|2||PSFJ8-xxx||Hard Chrome Precision Linear Shaft - Straight xxx mm|
For Prusa MK2(S) / MK3 x and y axis you need
|2||PSFJ8-370||Hard Chrome Precision Linear Shaft - Straight 370mm (x)|
|2||PSFJ8-330||Hard Chrome Precision Linear Shaft - Straight 330mm (y)|
For Prusa MK2(S) / MK3 z axis you need
|2||PSFJ8-320||Hard Chrome Precision Linear Shaft - Straight 320mm (z)|
16 other products in the same category:
Fully assembled E3D V6 hotend for Zaribo MK2, MK2.5. 12V version. Not compatible with MK3
Sunon fans come with long cable and with the necessary connector
Cable can be used to extend 3 pin fan cable or needed for Zaribo MK 2.5 or Prusa MK 2.5 to connect Noctua to RAMBO board.
This is a replacement Heat Break for E3D V6 1.75mm Bowden and Direct HotEnds.
A custom made thermistor encapsulated into an easy to use cartridge packag
430mm Extrusions for z-axis for Zaribo 320
Extends the motor cable. 20cm length.
Small Size 250W 12VDC 20A Switching Power Supply,
- Size: 199*98*50mm
Stainless, magentic Flexplate (254mm x 241mm)
crimped cables 60cm, 2 pairs (black and red)
Small Size 250W 24VDC 10A Switching Power Supply.
Upgrade kit for MK2.5 MK3 (NO drive gear included)
Complete motor kit for MMU2. 3 motors.