AC-DC Single Output Enclosed power supply; Output 24VDC Single Output at 13.4A; PFC; forced air cooling; 1U low profile
Zaribo 220 MK3s kit
Pleas allow up to 10 days for plastic parts.
Kit version: contains all parts to build the Zaribo 220 MK3s
- Genuine Ultimachine Einsy board
- original E3D hotend
- buildtak flexplate and print surface
- original bondtech extruder gear
- Misumi extrusions for frame
- Misumi smooth rods for for all axis
- Misumi bearings
- Misumi T-nuts
- Misumi metal corner brackets
- Misumi L-brackets for z-axis
- Misumi slot covers
- IR Filament sensor
Print height 220mm.
16 other products in the same category:
Upgrade kit MK3 -> MK3s including sensor, cable, steel ball, magnets, screws
Dowel Pin 2.9mm x 14mm for x-idler
LCD, cable length 70cm. Zaribo frame is a bit bigger and this cable is ideal for it, since it's longer than "standard" cable of 60cm.
The set has 2 cables for connection of 1 LCD to controller board.
Extends the motor cable. 20cm length.
High quality aluminum, excellently machined, finished smoothly.
Set has two pieces
Bare board for 20x4 LCD
Fully assembled E3D V6 hotend for Zaribo MK2, MK2.5. 12V version. Not compatible with MK3
Zaribo MK2 -> Zaribo MK 2.5 upgrade kit. Compatible with Prusa MK2 -> Prusa MK2.5
Stainless, magentic Flexplate (254mm x 241mm)
Please allow up to 10 days before shipping when you order plastic parts.
This kit allows many different upgrade options:
Prusa MK2 -> Zaribo MK2
Prusa MK2.5 -> Zaribo 2.5
Prusa MK3 -> Zaribo MK3
Print height is 220mm.
Please note when you use a Rambo board we highly recommend to add our MOSFET kit as well. The plug connected to the RAMBO can melt and even damage the board.
Complete motor kit for MMU2. 3 motors.
High quality polyurethane timing belts with Kevlar reinforcement. Package contains 2m belt, enough for x and y axis.
A pack of 3 new and improved high temperature non-stick silicone socks for E3D HotEnds. Keep your heater block clean and well-insulated with a cosy blue sock, stylishly emblazoned with the E3D logo.