Insulated, individually tested as per IEC 60900
Extrudr BioFusion cherry red
0.8 kg Spool
Extrudr BioFusion is a new breed of excellent material, best suited for designers and makers who are looking for an extra shiny appearance of their printed parts. Besides the good and special looks, BioFusion is also stronger than standard PLA or PETG, so you can also use it for mechanical parts. The temperature resistance of the material is up to 75°C. As it is very easy to print and doesn’t require a heated bed or closed building chamber, not much experience is needed to get extraordinary results. Shine on!
- Super shiny look
- Good mechanical properties
- Temperature resistance up to 75°C
- Good Layeradhesion
- 100 % recycleable
16 other products in the same category:
Fully assembled E3D V6 hotend for Zaribo MK3. 24V version. Not compatible with MK2, MK2.5
Small Size 250W 24VDC 10A Switching Power Supply.
Lead screw integrated z-axis motor for Zaribo 220 or stock Prusa MK2(S), MK3.
Dowel Pin 2.9mm x 14mm for x-idler
1m high quality PFTE tube for Bowden tubing. Not recommended inside the extruder.
Extremely sharp blade for precision cuts even of fine strips. Ideal for paper, film and thin materials.
Set of 10 blades
Push-fit connector for 4mm PFTE tube. M10 thread.
Full kit of high quality stepper motors Zaribo 320. All motors by LDO.
Stainless, magentic Flexplate (254mm x 241mm)
Pack contains 1.5m red and 1.5m black 14AWG cable.
Length is sufficient for wiring PSU to Einsy or Rambo box on Zaribo frame.
Cutter for Bowden tubes.
DIN 562, M3, 1.7mm thick
The Mosquito Magnum prints up to 20% faster than any other hotend on the market A thermal insulator protects the extended melt zone from the effects of active cooling, and radiative heat loss. It has a heat transmission rate as low as 3 W/m*K, meaning you can have ultimate confidence in the speed of your print, while at the same time maintaining the high resolution benefits achieved with the standard Mosquito The melt zone is extended proximally upwards to maintain a small form factor A multi extrusion setup with both high flow and high resolution optimized designs can be created without needing to purchase new nozzles or make carriage modifications to accommodate hotends of different sizes
0.8 kg Spool
LM8UU Linear Bearings by Misumi / THK