LCD cable 60cm set
LCD cable, cable length 60cm.
Set of 2 cables.
16 other products in the same category:
A pack of 3 high-temperature non-stick silicone socks for E3D HotEnds. Keep your heater block clean and well-insulated with a cosy blue sock, stylishly emblazoned with the E3D logo.
1m high quality PFTE tube for Bowden tubing. Not recommended inside the extruder.
Pack contains 1.5m red and 1.5m black 14AWG cable.
Length is sufficient for wiring PSU to Einsy or Rambo box on Zaribo frame.
Upgrade kit MK3 -> MK3s including sensor, cable, steel ball, magnets, screws
LDO Pancake Extruder Motor
LCD, cable length 70cm. Zaribo frame is a bit bigger and this cable is ideal for it, since it's longer than "standard" cable of 60cm.
The set has 2 cables for connection of 1 LCD to controller board.
High-Quality Graphics LCD Display, 20x4 text display, with a flat(!) potentiometer for contrast which is fully compatible
Bare board for 20x4 LCD
Stainless, magentic Flexplate (254mm x 241mm)
This is a replacement Heat Break for E3D V6 1.75mm Bowden and Direct HotEnds.
242X260 0.20mm Thick PEI sheet for Prusa MK3 Spring Steel Sheet with 468P 3M Adhesive on Glossy side
Dowel Pin 2.9mm x 14mm for x-idler
crimped cables 60cm, 2 pairs (black and red)
Solid, stranded and fine-stranded conductors with different cross sections can be connected. In Zaribo it's used in the Rambo-box. Package contains 4 terminals.