2x motors with 520 lead screws, 3x motors for x,y,e
Genuine Rambo Mini 1.3a by Ultimachine
This is Mini-Rambo v1.3a. The Mini-Rambo board is an all in one 3D printer motherboard.
This is Mini-Rambo v1.3a. The Mini-Rambo board is an all in one 3D printer motherboard. It is a compact version of our RAMBo v1.3L design with the Arduino MEGA and stepper drivers all on one integrated PCB. A great alternative board if you need just the basics!
Major Features - 4 x integrated 1/16th microstep motor drivers, 4 PWM Mosfet outputs, 3 thermistor inputs, pwm motor current control (no tiny knobs to tweak), SMPS supports hostless printing on power supply voltages from 10-28V DC, 2 fuse protected power rails (Heated Bed, 15A 10-35V, and Primary Power 10A 10-28V: Motors (5A dedicated fuse) + Extruders, Fans, & Logic (5A dedicated fuse)), LUFA USB, high quality connectors, did I say hacker friendly ...
Firmware / Hardware Information -
Mini-Rambo is designed to work with the current RAMPS generation firmwares with minimal modifications to add firmware pwm motor current control and the microstep setting pins.
Linux and Mac use CDC interface and have hardware driver built in. Mini-Rambo Windows hardware driver: RAMBo_USBdriver.zip
A preconfigured Marlin Firmware is preloaded onto the board. To re-flash this board, you can simply use the Arduino IDE with Rambo Addons and set board to "Rambo". There is an Arduino plugin folder on github that exposes additional pins in the Arduino IDE.
Recommended Power supply 12V-28V DC, 16A+.
Additional information and sources at RepRap.org/wiki/MiniRambo. This board is Open Source Hardware licensed GPLv3, so please use, copy, improve, hack, upgrade, and / or contribute.
16 other products in the same category:
Pack contains 1.5m red and 1.5m black 14AWG cable.
Length is sufficient for wiring PSU to Einsy or Rambo box on Zaribo frame.
Solid, stranded and fine-stranded conductors with different cross sections can be connected. In Zaribo it's used in the Rambo-box. Package contains 4 terminals.
Lead screw integrated z-axis motor for Zaribo 220 or stock Prusa MK2(S), MK3.
Cable can be used to extend PINDA 2 cable or needed for Zaribo MK 2.5 or Prusa MK 2.5 to connect PINDA 2 to RAMBO board.
Filament sensor for MK2.5 and MK3
Sunon fans come with 25cm cable. This version has NO plug
This is Einsy Rambo 1.1a. The Einsy Rambo board is an all in one 3D printer motherboard. It is a compact version of our RAMBo v1.3L design with the Arduino MEGA and stepper drivers all on one integrated PCB. A great alternative board if you need just the basics!
Extends the motor cable. 20cm length.
Power switch with light, CE, VDE
Upgrade kit MK3 -> MK3s including sensor, cable, steel ball, magnets, screws
A pack of 3 new and improved high temperature non-stick silicone socks for E3D HotEnds. Keep your heater block clean and well-insulated with a cosy blue sock, stylishly emblazoned with the E3D logo.
High-Quality Graphics LCD Display, 20x4 text display, with a flat(!) potentiometer for contrast which is fully compatible
High quality stepper motor for x-, y-axis or for use in extruder.