Helps 3D printer equipped with the controller board (capable of max 15A) become more powerful. With this add-on module to board lead the maximum current up to 25A.
Privacy Policy
Delivery Policy
Terms and Conditions
Helps 3D printer equipped with the controller board (capable of max 15A) become more powerful. With this add-on module to board lead the maximum current up to 25A.
If you intend to use heated bed with your 3D printer that uses a 12V power supply, then this module is recommended, else it may cause excessive current during times which may burn the connectors on the controller board, According to the thermal power of the bed, please choose the appropriate power supply, with sufficient margin. If it is large power heated, we suggest 24V power supply, under the same power requirements, current is less than 12A.
Dimensions: 60*50mm
Net Weight: 25g
Color:Black
Max Current: 25A(Enhance heat dissipation)
NOTE: This MOSFET is for DC only. It may burn when running recent Prusa firmware which powers the heat bed in PWM.
Helps 3D printer equipped with the controller board (capable of max 15A) become more powerful. With this add-on module to board lead the maximum current up to 25A.
MK3s including sensor, cable, steel ball, magnets, screws
PLEASE SELECT CONNECTOR TYPE
Lead Screw Length 320mm, can be used for stock Prusa
5V - NF-A4x10 FLX is a highly optimised, premium quality quiet fan in 40x10mm size.
Genuine MK52 with high-quality strong magnets, genuine thermistor and cable
Helps 3D printer equipped with the controller board (capable of max 15A) become more powerful. With this add-on module to board lead the maximum current up to 25A.
Sunon fans come with 65cm cable and with the necessary connector.
PH6 to JST 4p 24AWG Extra Long High-Quality Motor Cable
