Please scale up %100.34 while printing with ABS/ASA to compensate shrinkage. 

***************************************

1st October 2022

Z Axis Carriages.stl

The M3x22 screw slot tolerance increased for better compatibility with various screw brands.

***************************************

10th August 2022

Z Cable Lift.stl

Some nut holes expanded slightly for compatibility with more printers.

***************************************

7th August 2022

Alignment Tools.stl

Frame alignment tool has been updated according to the new LDO Aluminium extrusion batch.

***************************************

26th June 2022

Knob and Slot Cable Clips.stl

Cable clips are labelled as 20 and 30 according to the extrusion size.


Alignment Tools.stl

Heated bed alignment tool updated. The front distance changed to 12cm from 12.5cm

***************************************

22th May 2022

Extruder 0.2mm Parts.stl

Filament Sensor Ball Holder on the ZOrbiter Extruder improved for more smooth filament entry when insertng filament. Helpful specially if the filament tip is not perfectly straight.

***************************************

2nd May 2022

Spool Roller.stl

Spool roller legs are extended 40mm and the guide that connects with Pneumatic Fitting has been extend up as well to achieve better angle when the amount of filament decreased. 


Z Axis Motor Holders 1 2.stl
Z Axis Motor Holders 1 2.stl

The slot has been extended for the 60 x 5mm D Shaft due to manufacturing tolerances. (Some shafts measures as ~61mm)

***************************************


20th April 2022

- Alignment Tools.stl

1- Reduced the mass for less filament usage.

2- Although it is not a "must have" for the bed, heated Bed alignment tool added. Bed alignment on ZLC does not have to be ultra precise because ZLC does not require an XY Calibration. The heated bed is 310 x 325 in size and the build volume is set to 300 x 300 so you have 5mm space on sides and 20mm space on front and back. As long as your bed surface is within these margins you will get decent prints. The distance from left should be 7.5mm and distance from front should be 12.5mm. We added a tool to easily algin the bed without measuring with a ruller.

3- Previously we added a bottom hole on the Aluminium Extrusion Frame alignment tool to make it more stable. Later, by the help of user feedback, we modified the frame alignment tool to let you align two side extrusitons at once.


***************************************

10th April 2022

- Z Cable Lift.stl
Cable support part added.

***************************************

20th March 2022

-Extruder Bearings Cover: 
Endstop has been sticked out to increase compatibility with different brands.

-Extruder Belt Holders: 
Design improved for easier assembly.

-Y Axis Tensioners: 
L R lables added to avoid confusion on assembly. Nylock Nuts haave been replaced with square nuts for reliablity.

-PSU Body and PSU Cover:
Alignment issues fixed for the Power Socket assembly.

-PSU Holder:
Thickened for better grip.

-Z Cable Lift 2020 Mount
M5x8mm screws replaced with M5x10mm to reduce the screw variety.

-Frame and Rail Alignment Tools
The hole under the Frame Alignment Tool expanded for easier mounting.


***************************


-Bed and DIN Rail Mounts.stl
The DIN Rail holders were for 7.5mm off standard. Updated to 8mm Standard.